TKS-M2A AC220V Motor Controller Forward and Reverse Motor Control Board with Limit Iinterface Drive Module Liftin SCR Output

MotorsTKS-M2A AC220V Motor Controller Forward and Reverse Motor Control Board with Limit Iinterface Drive Module Liftin Motor SCR Output Specifications:Model: TKS-M2AVoltage: 220V 50Hz (available in 180-250V range)Suitable motor: two-way motor (3-wire or 4-wire) see wiring diagramOutput power: 300W (maximum current up to 16A, more than 300W pay attention to install the heat sink, so that the thyristor temperature control below 105°C)Output mode: bidirectional thyristorControl mode: switch signal trigger (pay attention to protection, the whole line is non-isolated, including the signal part)Protection circuit: with varistor (surge protection), input and output with X2 safety capacitor (eliminate spark interference and grid interference)Size: 90*50*28 (mm)P0 Standard Edition - Self-locking, the signal only needs to be triggered once, the module self-locking always runs.When the reverse signal is encountered during the forward turn, stop immediately and enter the reverse after 0.3 seconds.The limit signal is preferred, and the positive limit signal will be stopped immediately when it is encountered.Do not start forward turn when there is a forward turn limit signal. The same goes for inversion.The forward signal and reverse signal are effective at low power times, that is, a short 0V level (the negative terminal of the power supply) will start.The limit signal is normally open. (For example, SW1 switch is closed or connected to low power, can not start the forward rotation)Note:1. Due to the light and screen difference, the item's color may be slightly different from the pictures.2. Please allow 1-3cm differences due to manual measurement.Package Included:1x Motor Controller==========Motor Type : Motor

• Motors
• TKS-M2A AC220V Motor Controller Forward and Reverse Motor Control Board with Limit Iinterface Drive Module Liftin SCR Output