Meiwa Gravure REN-14 REN-14 Floor Peel and Stick DIY Renove Sheet, Patterned Tile, 17.7 x 94.5 inches (45 x 240 cm), Ivory Made in Japan

Surface that can be applied to: Surfaces that can be applied ■ Wood flooring, PVC cushion floor, tile, hard PVC floor x: Non-stick surface ■ Solid wood, tatami mat and carpet How to remove the protective film: The back of this product is attached to a protective film to protect the surface that is being applied. Please be sure to check the following when removing the protective film. 1. Please check the seal of the opening opening. ■ Please check that one end of the protective film on the back has a peel seal on it. In the event that the peel seal has been cut off by a size cut, please use a commercial tape with strong adhesion. 2. How to remove the protective film ■ Press the adhesive side of the peel-stick seal with your finger and rub the corners of the sheet with a claw. 3. Notes when applying this product. ■ Peel off the protective film evenly on the left and right side. Please be aware that pulling it too much may cause peeling or some pulling may cause the product to be creased. Precautions for Use: ■The floor may be damaged depending on the condition of the floor surface that this product is affixed to (such as aging), etc. ■This product will adhere to smooth surfaces. Please avoid using on uneven surfaces as the adhesive strength may weaken. ■ Please make sure to wipe off moisture and dirt on the floor before sticking. Do not stick on the floor when it is dirty or wet. ■Since glass fiber is used in the middle layer, you may feel irritation especially if you rub the edges of this product, especially if you have sensitive skin or allergies. In the event that irritation occurs, please wash thoroughly with soap or similar materials. ■ Please avoid using in direct sunlight or in environments where it is exposed to high temperatures and humidity. ■ Please be aware that rubber products (furniture leg rubber and casters, etc.) and other agents such as anti-aging agents and furniture and floor materials, preservatives, and insecticidents may contaminate this product and cause deformation or discoloration. ■Please be careful not to overload or load on this product. - The heat-resistant temperature of vinyl chloride resin is approximately 140°F (60°C). Do not use in areas where direct contact with fire or surface is high temperature. ■ If you are concerned about the smell of the product, please dry it in a shady place with good ventilation for one day. ■ Wipe off with a wet cloth while remaining light. If it becomes seriously dirty, wipe it gently with a dish cloth that is infused with mild soap in the kitchen. Please remove detergent thoroughly after removing the dirt. ■ Clean the dirt on the back with running water. Do not use in wet conditions. ■ Water can flow through the back and moisture from the bottom of the floor may cause condensation between the floor and the product. Please be aware that this may cause mold. ■ Please note that the protective film is not necessary.

• You want to change the image of the floor, but it is difficult to install and hassle... And because rental houses need to return to their original state, you can't go through it. The Meiwa Gravure Peel and Stick Renove Sheet is recommended for those who do so. It can be applied and peeled off, so it can be used safely even for rental homes. No need for troublesome installations. You can change the look of the floor surface of your kitchen, living room, bathroom, etc
• ■ Peel and Stick The back is made of special acrylic resin material, so it can be attached to the floor surface
• ■ Safe for rental homes, can be applied and removed so it can be used safely even by people in rental homes
• ■ Ultra-thin 0.01 inch (0.3 mm) thickness is 0.01 inch (0.3 mm) so it is difficult to stumble and can be used without any stress when vacuuming
• ■ Waterproof and easy to care for, the surface is made of PVC material, so if it gets dirty, just wipe it away!